Owatrol Polytrol

Owatrol PolytrolRevives Faded Plastic, Fibreglass, Paint, Metal, Tiles in Minutes. Photo shows both plastic and paintwork revived on an old car door. Like a Plastic Polish restores the colour and appearance of dull and faded surfaces caused by exposure to sunlight, rain and pollution Deep penetrating oil that restores the original look and finish to gel coat, plastic, metal and other surfaces Protects against corrosion and blemishes On bare metals Polytrol restores

Revives Faded Plastic, Fibreglass, Paint, Metal, Tiles in Minutes. 

Photo shows both plastic and paintwork revived on an old car door.

• Like a Plastic Polish restores the colour and appearance of dull and faded surfaces caused by exposure to sunlight, rain and pollution 
• Deep penetrating oil that restores the original look and finish to gel coat, plastic, metal and other surfaces 
• Protects against corrosion and blemishes
• On bare metals Polytrol restores the shine and protects against corrosion  

Properties

• Revives the colour and appearance of tarnished and dulled plastics and fibreglass (GRP) (car bumpers, boat hulls, plastic garden furniture, shutters). 
• Restores marble, tiles, tombstones, slate, terracotta tiles where the colour and look has faded. 
• Rejuvinates and restores flat and chalky paint and varnishes dulled by weathering. 
• Restores the shine and protects chrome or polished metals: aluminum, chrome, brass, bronze  

Where to Use 

• Treat small areas in stages to avoid an uncontrolled drying of the Polytrol. 
• Avoid using Polytrol on hot surfaces or direct sunlight. 
• Although Polytrol is not highly flammable, soaked rags should not be discarded as such directly to the trash (risk of self-ignition) leave cloth to dry first in open ventilated place.  

Application 

• Before using Polytrol plastic polish, always make sure the surfaces are dry, clean and free of grease, silicone. If cleaning is necessary, use a solvent on metal or use Net-Trol on plastics. Rinse well and allow to dry for at least 12 hours. Mask areas that are not to be treated. 
• Carefully apply a layer of saturated Polytrol. Beware of runs (for sanding metal surfaces, use fine steel wool, well soaked with Polytrol). 
• Leave on for 10-20 minutes then remove the excess product by wiping with a clean lint free or paper towel. 
• Allow at least 24 hours before use. 

Coverage: 18m²/l  

Application tools : brush - cloth 

Application temperature : +5°C to +35°C 

Working time before wipe off : 10 to 20mn.

Clean-up : White-Spirit

Polytrol is available online here now. 1/2L, 1L & 250ml Aerosol.