8 fader 8 knob 8 button USB and DIN MIDI Controller

8 fader 8 knob 8 button USB and DIN MIDI ControllerUSB and Din MIDI Controller custom with 8 Faders,8 knobs and 8 buttons. Detachable Type C USB connection (2m Type C to Type A cable included). Hand assembled and painted with a golden pine finish or black on 3mm plywood. The picture used of the controller is an example of the finished look, due to the nature of wood and wood grain each controller will have a slightly different finish and can result in a darker and lighter finish or different wood

USB and Din MIDI Controller custom with
8 Faders,8 knobs and 8 buttons.
Detachable Type-C USB connection
(2m Type-C to Type-A cable included).

Hand assembled and painted with a golden pine finish or black on 3mm plywood.

The picture used of the controller is an example of the finished look, due to the nature of wood and wood grain each controller will have a slightly different finish and can result in a darker and lighter finish or different wood grain pattern then the one pictured.

The box dimensions are 200mm x 180 mm x 35mm.
The fader travel is 60mm.

The knobs are potentiometers and are the Knob version that stop
(only turn 270 degrees 7 to 5 o’clock)

This version has 3 presets (3 banks) that saves the CC# of each fader,knob and button.
The two buttons next to the LED display change the preset - left button decrease and right button to increase.

Each button can be individually programmed when pressed to send either:
Control Change messages (1 to 127),
Program Change messages (1 to 127)
or MIDI note on /off message notes (1 to 127).

When a button is pressed the display will show the button message value (1 to 127).
The faders/knobs when moved send control change messages and the display shows the output value.
The buttons can be set to Toggle or Momentary mode

The MIDI channel of the controller can be set from 1 to 16 or each fader and buttons can each be set individually to different channels.

All changes are done using the display and small button located on the USB side of the box
no extra software is needed

The faders and buttons can be MIDI learn/mapped in your DAW software or used with hardware that responds to control change messages and program change commands

The Program change value is 0 to 127 some devices see this as 1 to 128
The control change ON value is 127 and the OFF value is 0

will not work with VirtualDJ
Instructions on how to program the controller are below