AC Vent 3D Carbon Blackout Overlays - 2015-2021 WRX / STI / 2014-2018 Forester / 2013-2017 Crosstrek

AC Vent 3D Carbon Blackout Overlays - 2015-2021 WRX / STI / 2014-2018 Forester / 2013-2017 CrosstrekAC Vent 3D Carbon Blackout Overlays Add some texture to the interior of your vehicle. Sticker Fab make a number of products for these vehicles. The 3D carbon vinyl is easy to apply and really durable. Protect areas against scratches and cover up old scratches. MATERIAL DETAILS Dragon Wrap Carbon Fiber Film is a 5. 6 mil calendered vinyl film featuring a clear repositionable permanent acrylic adhesive on an air egress liner. This film has excellent

AC Vent 3D Carbon Blackout Overlays

Add some texture to the interior of your vehicle. Sticker Fab make a number of products for these vehicles. The 3D carbon vinyl is easy to apply and really durable. Protect areas against scratches and cover up old scratches.

MATERIAL DETAILS

Dragon Wrap™ Carbon Fiber Film is a 5.6 mil calendered vinyl film featuring a clear repositionable permanent acrylic adhesive on an air-egress liner. This film has excellent dimensional stability, outstanding durability and outdoor performance. This repositionable permanent adhesive offers minimal initial bond growing to permanent bonds that facilitates application of large graphics. The air egress liner also aids in large graphic application.

Lasts up to 5 years outdoors.

Care Details: Concept Carbon Fiber film should be maintained to preserve long term appearance using standard aftercare products designed for textured exterior vinyl surfaces. A commercially available protectant such as Armor All or 303 Aerospace Protectant is recommended. DO NOT use waxes of any type.

INSTALLATION NOTES

Clean the application area and make sure it is clear of any dirt, debris, and/or Armor All. Please refer to the installation notes in the photos above. The adhesive is also pressure activated. Just keep that in mind. Finding the center is really the key to installing these. You can gently guide the material as you apply it. All you need is to use your fingers though. We don't recommend a squeegee or anything hard. The material is forgiving and can gently be pulled back up if you need to realign it.

Use of a little heat from a heat gun or hairdryer (preferred) can help increase adhesion and allow you to stretch the material if you misaligned it and just need a little extra coverage. Please use small amounts of heat.